I got a *** ERG delete kit when I ordered my stuff from DRD. I got through what I thought was supposed to be the hard part and got the parts off. As I started putting things back together following the directions I began to realized that I was going to have parts left over and would be needing a new CCV hose as the directions and the set up pushed it too far out to make a solid connection on the connectors. The directions included from *** didn't mention anything at all about what I assume is the exhaust pressure sensor as to where its supposed to go or what to do with it. Does anybody have better pictures of the finished setup and any info that would help me finish this project?

Any and all help would be greatly appreciated!!!!

-Doc