3rd Gen Dodge RAM Tuning?

[Bud2723]

After looking for about six months, I finally found a 3rd gen in excellent condition, only 126k miles, and completely stock except for a small suspension lift.

I'm happy to say I own it now!

Im looking for a good tune for this truck to liven it up.

I'm unsure if Ray does it for the 3rd gens (fingers crossed he does), but if not, what do you guys recommend?

Does it include transmission tuning?

I'm not looking to make this into a drag truck, but I'm an excellent daily driver, can tow better, and maybe do some spirited driving on the weekend.



Sent from my SM-G998U1 using Tapatalk

 0 Comment(s)

[Corkey]

If it's 6.7L 3rd Gen, I recommend becoming a Plus member.

It's free and you'll get what you are looking for.

DRD has sadly taken an early departure on retirement.

Clean 3rd gen!

 0 Comment(s)

[Bud2723]

It's a 5.9 and I am already a member. I've been one since 2018 or so when I bought my 18 6.7 G56. I did read on hear about updating our info, but I'm not exactly sure where to do that or if I missed the window.

Sent from my SM-G998U1 using Tapatalk

 0 Comment(s)

[Corkey]

I could be mistaken; I don't think we do 5.9L's.

I know for a fact that we do the 6.7L's.

Might seek out a Smarty JR or something or perhaps edge to further assist in getting her to breath better.

 0 Comment(s)

[Bud2723]

Thanks for the response!

I did find a tuner for the 5.9L, and it's on the MM3 platform.

Too bad "The Man" is retiring/retired; he did well for me for my 6.7.

I have some brand-new parts that I never installed on my 6.7L.

Mainly the block-off plates from the man himself.

This may not be the right post for here, but if anyone is interested in them, please PM me and make me an offer.

If this isn't the right place to post, please move it to the correct location.

Thanks!

Sent from my SM-G998U1 using Tapatalk

 0 Comment(s)

[AK Bob]

Thanks for the response!

I did find a tuner for the 5.9L, and it's on the MM3 platform.

Too bad "The Man" is retiring/retired; he did well for me for my 6.7.

I have some brand-new parts that I never installed on my 6.7L.

Mainly the block-off plates from the man himself.

This may not be the right post for here, but if anyone is interested in them, please PM me and make me an offer.

If this isn't the right place to post, please move it to the correct location.

Thanks!

Sent from my SM-G998U1 using Tapatalk

I'm pleased you found a tuner; the MM3 platform is the way to go.

The best way to advertise your block-off plates is to start a new thread on the forum below.

https://www.igotacummins.com/forums/...h-Gen-Products

 0 Comment(s)