I hope everyone is well!

Yesterday I came upon an issue with my RaceME Ultra.

I installed a boost gauge in my RAM due to the RaceMe only reading to 36 PSI of boost (I am 2nd gen swapped), and after installation, I wanted to adjust some ranges on my Ultra. (Green into Red ranges)

Upon changing my Engine Coolant Temp 3rd range and pressing save, the Ultra seems to freeze up on a please wait for the screen, while simultaneously flashing the side light Green 4x and Red 1x, and continuing that flashing pattern indefinitely.

I recently (3 months ago) 2nd gen swapped and installed Ray's SD Card sent through the mail, and it also updated the Ultra to the latest software.

It has since been running great until this minor issue.

I can change the gauge layout and save it without issue, but I cannot change any gauge parameter ranges without this error.

To clear it, I have to unplug the Ultra from the OBDII port or unplug the Micro USB from the back of the screen.

If anyone has any recommendations, that would be very helpful.

I appreciate any help you can provide.