Good afternoon everyone!
I require some help.
I have a 2012 2500 4wd the I am pretty sure I require a new driver-side steering knuckle.
The tie rod ends, once torqued in is pulled up way too far into the taper.
At first, I thought it was just another junk Moog part that I got when I replaced the tie rod.
So I ordered a synergy one, and the result is the same.
The cotter pin hole is above the castellated on the nut.
I have been searching for one, but I can't find one anywhere.
Does anyone have some advice on where I could find one or maybe like a repair sleeve or something for the one that I have?
Any help would be appreciated.
Bookmarks