Thanks: 1
Likes: 6
Looking to mabey hook my truck to a sled at the local fair. Don't plan on beating the hell out of it. But I'm looking for some insight as far as what one of rays tunes I should run? Im assuming nothing to high cause of egts. What egt temps should I avoid? Put into 4th gear and go? 68RFE auto, and fully deleted.
Sent from my SM-G955U using Tapatalk
Jaxonsram liked this post
For pulling a sled the EGT won't be a huge issue you'll only be pulling for about 15-20 seconds including staging. Depending on what company they hire for the sled (Lowry) most likely. You'll probably be pulling around 20k. Temps will probably spike up around the 1200-1500° range depending on your setup
4hi
Low HP tune especially if your drivetrain is stock
Be safe and take extra u-joints with you for the rear shaft. They don't cost that much and a good chance pulling on dirt under load hopping you may chuck a set
Consider replacing them with HD before you pull to
If you decide to pull, get someone to take a video so you can share with all of us here.
Greg
2012 | RAM 2500 | CCSB | Custom tuned by Double R Diesel
2016 | Heartland Pioneer | DS310
Greg
2019 | RAM 2500 | CCSB | 6.4 HEMI
Hook as high as they say you can. 18, 20, 22 inches
did not get the chance to hook, i was helping my buddy with his 6.blow this weekend. he ended up pulling first in his class. Impressive truck i actually must say but theres a pretty penny in it!
Power247 liked this post
Posting Permissions
Register To Reply
Bookmarks