Has anyone installed additional dome / map lights

**nani** · 12-01-2016

I have a 14 2500, base model with a single dome light in the center.
Looking for some ideas to add more lighting to the interior, thanks!

0 Comment(s)

**Steinbrenner** · 12-01-2016

Interested as well.

Sent from my SAMSUNG-SM-N920A using Tapatalk

0 Comment(s)

**TX NIGHT TRAIN** · 12-01-2016

I know there are kits available that bolt in for the front and screw in for the rear. I'm not sure how I'd feel about cutting my liner to install them

0 Comment(s)

**Derek** · 12-01-2016

Have you tried replacing the bulbs with LED's ?*

0 Comment(s)

**nani** · 12-15-2016

Yeah, I switched the bulb to LED but its not enough. I found these dome light fixtures, Ill give it a shot and see how it looks installed.

0 Comment(s)

**nani** · 03-20-2017

I installed the lamp, had to pull down the headliner which was relatively easy. Remove sun visors, A and B pillar trim and removed the seatbelt bolts. I bolted the light with some small bolts and nuts and run some wire from the dome light to the drivers side a pillar cover. I found a green connector behind the drivers side air vent. I tapped into that for power and ground.

0 Comment(s)

**Power247** · 03-20-2017

Originally Posted by nani

I installed the lamp, had to pull down the headliner which was relatively easy. Remove sun visors, A and B pillar trim and removed the seatbelt bolts. I bolted the light with some small bolts and nuts and run some wire from the dome light to the drivers side a pillar cover. I found a green connector behind the drivers side air vent. I tapped into that for power and ground.

0 Comment(s)