Did you delete the grid heater also? When I deleted mine, I couldn't believe how sooted up it was!Originally Posted by raayyy_raayyy
Sent from my iPhone using Tapatalk
Thanks: 1,025
Likes: 4,138
Did you delete the grid heater also? When I deleted mine, I couldn't believe how sooted up it was!
Sent from my iPhone using Tapatalk
I didn't just yet but plan on doing it very soon, mine wasn't all that bad surprisingly. Didn't feel like tearing everything apart that's why I haven't done it yet haha.
2011 3500 SRW, 3" Carli Performance 2.0
Deleted and Tuned, EFILive, 5 inch Flo Pro Straight Pipe
18" wheels with 35" Toyo Open Country M/T
Have not yet deleted the grid heater yet, other fish to fry right now, but it's on my list of things to consider down the road. Hardly a need for it here in south Texas. But, I'd like to investigate the Pros & Cons.
Sent from my iPad using Tapatalk
Yeah I'm in Southeast Texas near Beaumont, no need for a heater here! I installed the GDP air horn and grid heater at the same time...install wasn't bad at all, just have to make sure you don't mix up the fuel lines! I payed them all out in order and labeled them as I pulled them off...I didn't have to take the 6th line off though. I was able to pull the existing heater out and slide the delete in with no issues...took about an hour and a half.
Sent from my iPhone using Tapatalk
4kids2dogs&RV thanked for this post
90 minutes isn't bad, thanks for the advise on labeling the lines.
Yea, I live in San Antonio, but I have family in NTX, OK, PA and VA that I still visit. So I'm not sure I'm ready to delete the heater just yet.
What are the benefits to deleting? Any cons other than cost and possible trouble if I go north in the winter months?
Increased air flow along with the Air Horn. Now my only restriction is the size of the inter cooler, but I don't plan to make huge horsepower, I just want it to breathe easy. GDP makes a remote Grid Heater that installs where the throttle valve is located...it's a lot less restrictive too.
Sent from my iPhone using Tapatalk
Bought a set of 37x12.5x20 nitto Terra's and sent it to the dealer for a 4.10 gear swap! Can't wait.
Sweet setup bud
2012 Cummins Ram 6.7L MM3 tuner full 5" Flo Pro TBE Exhaust LWBCC 4x4 Mag Hytec Double Deep Transmission Pan , Mag Hytec Rear Diff Cover
Airlift part # 57595 7500lbs airbags ,Nitto Ridge Grapplers 35/12.50/20 on XD 829 Big Hoss ll Satin Black Machined Dark Tint 20 x 9 with + 18 offset rims,MM3 Tuner With full Custom Tunes by Ray at DRD , Autometer A13117 Pillar Pod , Edge 98004 mount adapter , Mag Hytec front diff cover, SuperNova V4 LED Headlight Bulbs
IGOTACUMMINS thanked for this post
Got AFE CAI installed and my exhaust tip too.. woo hoo... baby steps LOL.
Sent from my SM-G920P using Tapatalk
2014 CUMMINS "BADGIRL" Laramie MC 3500 (Aisin) 4X4 MM3 Tuned by Double R Diesel*** EGR delete AFE CAI 4” FLO-PRO w/muffler 4" Zone lift, Federal Couragia 37’s with Black Rhinos,bed carpet kit, tail-gate assist, Retrax tunnau cover
Previous "Cummins Badgirls" :
2006 Cummins 2500 4x4
2012 Cummins 2500 4x4
IGOTACUMMINS thanked for this post
Awesome,sweet looking truck
Sent from my iPhone using Tapatalk
IGOTACUMMINS thanked for this post
Register To Reply
Bookmarks