DRD Tune - Pedal Commander - Left Tail Light?

[Talldrink44!]

I have been running my DRD tune for a while in my 2018 RAM 3500 with extreme weight loss success, but I have a couple of questions.

It does have the Aisin, so wanna get that out in front, but it seems like I have a lag that I’d like to get rid of if possible.

Would pedal commander help, or do I need to do something different?

I only run the SOTF tunes on 0 or 1 in the setup.

Daily driving, should I be using a different level?

I usually pull my skid steer in the 0 setting (recall being stock plus 30).

Any input or ideas are appreciated.

I also have times when I start the truck, the left rear turn signal will indicate out, and then less than a minute later, it’s normal.

I have also got in the truck on a night and started it, then the headlights go out, and the left rear turn signal is out.

Then all goes normal.

Do I need an update or something, or am I missing something?

I appreciate any help you can provide.

 0 Comment(s)

[AK Bob]

I have been running my DRD tune for a while in my 2018 RAM 3500 with extreme weight loss success, but I have a couple of questions.

It does have the Aisin, so wanna get that out in front, but it seems like I have a lag that I’d like to get rid of if possible.

Would pedal commander help, or do I need to do something different?

I only run the SOTF tunes on 0 or 1 in the setup.

Daily driving, should I be using a different level?

I usually pull my skid steer in the 0 setting (recall being stock plus 30).

Any input or ideas are appreciated.

I also have times when I start the truck, the left rear turn signal will indicate out, and then less than a minute later, it’s normal.

I have also got in the truck on a night and started it, then the headlights go out, and the left rear turn signal is out.

Then all goes normal.

Do I need an update or something, or am I missing something?

I appreciate any help you can provide.

I haven’t experienced any lag with my 2014 Aisin, but hopefully, others who have will chime in with recommendations.

The issues with your lights could be an intermittent ground issue.

I recommend a full system scan of all modules to see if you have any active or stored trouble codes.

 0 Comment(s)

[Talldrink44!]

Thank you.

That’s why I wondered if I was missing something that needed an update or did some data logging.

Well, I did that, ruling out the grounding issue at this point; it only does it in start-up and never while driving.

It is almost like a “booting up” process that is skipped and then finally catches up

 0 Comment(s)