Drag Link Replacement?

[jgruberman]

My drag link bar on my '14 RAM 2500 has both sides of the joints going out and is getting some crazy wobble.

I bought an OEM drag link bar from the dealer, and the bar is fully retracted, and the steering wheel still can't be adequately adjusted to be straight.

Does anyone have any experience with aftermarket replacements?

I'm not sure why this one isn't fitting, and the steering wheel is adjusting correctly, other than perhaps because I have a lift on the truck.

Any ideas?

Sent from my SM-S908U using Tapatalk

 0 Comment(s)

[CrazyTrain]

Your lift is the culprit.

Get an aftermarket, adjustable bar.

 0 Comment(s)

[CrazyTrain]

And if the joints in the old bar were shot, check all other components for wear as well.

I hate death wobble.

 0 Comment(s)

[jgruberman]

Your lift is the culprit.

Get an aftermarket, adjustable bar.

Any recommendations?

Sent from my SM-S908U using Tapatalk

 0 Comment(s)

[jgruberman]

The one that I pulled down looked like it was a Moog.

It had the turnbuckle style, and I could have sworn that I saw Moog etched into the link on the pitman side.

I'm about to be home and will take another look at it.

In a perfect world, I would like not to spend another $450 on a Synergy only because I just spent that much on the OEM bar that I cannot return now because it's been installed.

However, if I have to, then I have to.

Sent from my SM-S908U using Tapatalk

 0 Comment(s)

[IndyRamMega]

Synergy FTW.

They make great stuff.

Easy to install and adjust

JMO.

 0 Comment(s)

[jgruberman]

Synergy FTW.

They make great stuff.

Easy to install and adjust

JMO.

I assume the Synergy bar also works with a lift?

Any specific lift range?

Sent from my SM-S908U using Tapatalk

 0 Comment(s)

[jgruberman]

This is the bar that I removed.

The link on the small side says Moog on the joint, but the long shaft doesn't specify a name.



Sent from my SM-S908U using Tapatalk

 0 Comment(s)

[Corkey]

Synergy has a solid reputation behind its products.

Replaceable tie rod ends as well, instead of replacing the whole track bar.

 0 Comment(s)

[CrazyTrain]

Synergy is your best bet.

It sucks that you bought a stocker before you found it wouldn’t work.

Buy the Synergy and list the other one; somebody will buy it.

This is your learning moment.

I’ve had my share.

 0 Comment(s)