New Valve Body / Deep Pan - Now Code P0713?

[UglyGreen6.7]

So, guys, I’m hard-stuck.

I installed a new valve body and deep transmission pan.

I flashed the new tunes for the higher line pressure now P0713 ECM - Trans Fluid Temp Sens A Circ High.

I’m at a loss of where to go next; I checked for bent pins.

Does anyone have a wiring diagram for the harness side?

I know it’s pin 23, but I can’t find what resistance it should be at!

It’s a 2013 RAM 2500, by the way.

Thank you for the help!

 0 Comment(s)

[AK Bob]

Attached is the code troubleshooting information with the wiring circuit for 2014, 3500.

Hopefully, this will help.

 0 Comment(s)

[UglyGreen6.7]

I want to thank you, Bob found a secondary wire that was pushed back from the plug side, reseated the wire, and the code cleared!

Thank you again!

For future reference for anyone, check resistance, double-check the plug wires and all three sensors on the transmission, and finally, least likely, make sure the fluid level is correct.

 0 Comment(s)