Amsoil Bypass Filter?

[olyeller40]

Hi, all.

I need some help.

I have an Amsoil bypass filter for my 2012 Cummins.

Where do you put the pressure line on the filter housing, and what does it take to complete?

Thanks.

 0 Comment(s)

[AK Bob]

On my 2014 I removed the 1/8” NP plug from the top of the factory oil filter housing and installed a 90-degree fitting for the oil supply line.

 0 Comment(s)

[olyeller40]

Thanks.

But on top of the oil filter housing there is 2 fittings the 1 on the inside I have to take off a hard coolant line is the 1 you can get out and put the 90° fitting in.

Thank you for your help.

 0 Comment(s)

[Jwaller]

I know I watched a YouTube video made by amsoil on the install.

I will try and find it.

I haven’t done this mod, but was looking at it.


2021 Ram 2500 Crew Can SB, Billet Silver Night Edition, Tuned by CCS/EFI Live, 5 position SOTF, 5” exhaust with Aeroturbine 5050xl resonator/muffler, S&B Intake, 295/60’s on stock 20’s.

 0 Comment(s)

[AK Bob]

Thanks.

But on top of the oil filter housing there is 2 fittings the 1 on the inside I have to take off a hard coolant line is the 1 you can get out and put the 90° fitting in.

Thank you for your help.

See this video 6:33 minutes in.

 0 Comment(s)

[olyeller40]

Thanks for helping me, but I have 2 1/4" plugs on the top of the filter housing.

For one, I would have to remove a coolant hard line to put the 90° fitting in.

For the other one, I can get to it easily, put the 90° fitting in, and finish up, but I don't know.

 0 Comment(s)

[IndyRamMega]

Thanks for helping me, but I have 2 1/4" plugs on the top of the filter housing.

For one, I would have to remove a coolant hard line to put the 90° fitting in.

For the other one, I can get to it easily, put the 90° fitting in, and finish up, but I don't know.

Did you figure this out?

I can take a pic of mine if you need help.

 0 Comment(s)

[KJC]

Either fitting on top of the oil filter housing will be fine.

Use the one that is easily accessible.

 0 Comment(s)

[olyeller40]

Yes, I did.

I talked to the Cummins diesel doctor, who told me to put it right in the middle quarter-inch plug on top of the filters where that went, but thanks for your help.

Sorry, it took so long to reply.

 0 Comment(s)

[olyeller40]

Thanks for the help.

If it's in trouble, can you take a picture?

I want to make sure.

Thank you.

 0 Comment(s)