What grease do you all use?
I used Mobil EP2, but I’m unsure if that’s the best option.
Sent from my iPhone using Tapatalk
What grease do you all use?
I used Mobil EP2, but I’m unsure if that’s the best option.
Sent from my iPhone using Tapatalk
I use Lucas red and tacky, same stuff for my Kubota.
2010 Dodge 2500 SLT CCLB 4WD G56 Cummins 6.7 turbo diesel, 3.42 LSD. Add ons: Banks Monster Ram, Grid heater delete, Spyntec Free Spin Kit with Warn hubs (62672) Laramie Alloys (includes spare), "Powerwagon" Flares, Powerwagon bed decal (4X4 off road) OE Ram mudflaps, OE Slush Mats, OE Clearance Lamps, Geno's shift knob in black, 5" DPF back with muffler delete, spray in bedliner, OE brake controller, Durafit Seat Covers, Pro Tech Toolbox, Speed Turtle, Upfitter switches, Ham Radios, 8 Antennas, headache rack, emergency light bar,....
Drive shaft u-joint?
Aluminum shaft?
They will need to be anti-galvanic type.
https://www.moogparts.com/parts/driv...al-joints.html
2014 RAM 3500 (Aisin) 3.73 4X4 Limited Crew Cab Long Bed DRW. Oil Bypass Filter, Fuel Filtration Kit, Cold Air Intake, City Diesel Actuator and 50 Gallon Aux Fuel Tank.
I read AAM u-joints are used in the aluminum shafts.
Nobody can verify.
I pulled my shaft out twice to check joints and took it to the drive shaft shop.
They said it was out of balance but the joints ok—175k on the joints.
I feel they are bad as I have a vibration in the rear.
I'm checking my rear tires tomorrow at the tire shop and getting them road force balanced.
I also have a pinion seal leak but zero movement in the pinion.
Getting that looked out on Wednesday, so I will see if they find anything more.
Bookmarks