Can I make my MM3 show the trans temp?
I haven’t been able to figure that out yet.
Thanks.
Thanks: 8
Likes: 23
Can I make my MM3 show the trans temp?
I haven’t been able to figure that out yet.
Thanks.
2018 3500 Single Cab DRW 4x4 H.O., Aisin Trans, Nitto Ridge Grappler 295/65R20, Fuel Wheels, Smoked LED’s All Over.
Never Forget 343
IGOTACUMMINS thanked for this post
Yes, you can monitor the trans oil temp.
It's not perfect, but it will give you good data.
As far as getting there, when you are on the gauge monitoring screen, click on it, then click on the spot that says configure (lower middle).
Click on any gauge square or dial, and it will take you to the options screen, where you can scroll through and change things.
Look for transmission, click on it, scroll down and locate trans oil temp.
You can set up warnings and temp levels.
It's cool.
Have fun!
- Happy to be on the food chain at all…
- Full-Medium-Speed
That process doesn’t work on mine.Originally Posted by Tjswa666.7l
I click transmission, and then all I get is Transmission Limp In Status.
Any other advice?
2018 3500 Single Cab DRW 4x4 H.O., Aisin Trans, Nitto Ridge Grappler 295/65R20, Fuel Wheels, Smoked LED’s All Over.
Never Forget 343
IGOTACUMMINS thanked for this post
Unfortunately, you can’t display the transmission temperature on your MM3 if you have the Aisin transmission.
If your gauge cluster (EVIC) doesn’t provide that information, you need to use a scan tool or add an aftermarket gauge and sender to monitor.
2014 RAM 3500 (Aisin) 3.73 4X4 Limited Crew Cab Long Bed DRW. Oil Bypass Filter, Fuel Filtration Kit, Cold Air Intake, City Diesel Actuator and 50 Gallon Aux Fuel Tank.
It does show it in my gauge cluster, but I prefer to have my speedometer shown there.
Oh well, thanks anyways, bud!
2018 3500 Single Cab DRW 4x4 H.O., Aisin Trans, Nitto Ridge Grappler 295/65R20, Fuel Wheels, Smoked LED’s All Over.
Never Forget 343
IGOTACUMMINS thanked for this post
Posting Permissions
Register To Reply
Bookmarks