I have two Turbos for sale.
Both were used in a Pusher compounds kit on stock fuel and have approximately 25k miles.
- Fleece Cheetah drop in for 13-18 4th Gen Cummins
- Borg Warner S475/96/1.32 T6
Cheetah - $1250
BW - $500
$1600 for both.
I have two Turbos for sale.
Both were used in a Pusher compounds kit on stock fuel and have approximately 25k miles.
- Fleece Cheetah drop in for 13-18 4th Gen Cummins
- Borg Warner S475/96/1.32 T6
Cheetah - $1250
BW - $500
$1600 for both.
Do you have everything to put that Fleece turbo in a stock turbo truck?
I just have the turbo.
You will need a new exhaust flange gasket, turbo oil drain gasket, and coolant banjo sealing washers.
Besides that, it drops right into your stock turbo location.
What are your plans for a new setup?
16 cummins Laramie longhorn, ccsb, 35x12.5x20 xplora mts ,tis wheels,fully deleted, pusher add a turbo kit,stainless diesel 475 5blade turbo over 63mm VGT delete turbo,manton springs, manton valve bridges,manton pushrods,ARP 625 headstuds,steedspeed t4i manifold , S&S 80% over injectors, thuren rear trackbar, kingspeed billet valve cover, revmax valve body billet plate, CCV reroute, pusher intake horn, thuren 2in level with king 2.5 front and rear, sway bar kit ,track bar and king steering damper. Air bags from airlift. 4" exhaust, fass lift pump,MM3,DRD tunes.pusher coolant reroute.
I wanted to try something new.
So went with a WC Fab 2nd Gen right before they discontinued them.
Did a 467 on some BBI 1.5s.
Nice, that should be pretty stout.
Any other fuel mods?
16 cummins Laramie longhorn, ccsb, 35x12.5x20 xplora mts ,tis wheels,fully deleted, pusher add a turbo kit,stainless diesel 475 5blade turbo over 63mm VGT delete turbo,manton springs, manton valve bridges,manton pushrods,ARP 625 headstuds,steedspeed t4i manifold , S&S 80% over injectors, thuren rear trackbar, kingspeed billet valve cover, revmax valve body billet plate, CCV reroute, pusher intake horn, thuren 2in level with king 2.5 front and rear, sway bar kit ,track bar and king steering damper. Air bags from airlift. 4" exhaust, fass lift pump,MM3,DRD tunes.pusher coolant reroute.
I am probably looking for a new actuator and thinking about compounds, and I might be interested.
I am interested in your Fleece Cheetah if it’s not sold.
@Palladium
Fleece PowerFlo lift with an exergy 10mm CP3.
Very happy with this setup.
I like to try new configurations, but this one is pretty hard to beat.
Although I wish I had done these fueling upgrades with my compounds.
Still available, PM me.
Bookmarks