I installed my EGT probe a couple of weekends ago.
The temps were not significantly higher than what I was reading before on the factory post turbo probe.
I looked at it last night and noticed that I might not have installed the probe with the tip deep enough (plenty of jokes there for sure) to get accurate readings.
Do I need to loosen this and install it deeper?
There is about 1" of the distance between the end of the fitting and the 90 bends for reference.
I would have already tried it, but I am assuming the ferrule is one-time use and would need to be replaced if I loosen it?
I appreciate any help you can provide.
Bookmarks