Does anyone have any experience or advice on tightening the nut for the pulley on a fleece dual pump kit?
The pulley is slipping on the belt, so I can’t get the nut torqued down.
Sent from my iPhone using Tapatalk
Does anyone have any experience or advice on tightening the nut for the pulley on a fleece dual pump kit?
The pulley is slipping on the belt, so I can’t get the nut torqued down.
Sent from my iPhone using Tapatalk
2016 Ram 2500/ /G56/ /Valair ceramic DD/ /WC fab 2nd gen swap/ /Stainless diesel 5 blade S468/83/1.0/ /Banks monster ram/ /Isspro gauges/ /MM3 tuned by DRD/
Might need two people but, I turn the tensioner opposite direction to put extra tension on the belt if it slips.
Works for removing fan clutch’s too.
Sent from my iPhone using Tapatalk
That might do it.
I will have to give it a shot this weekend.
Thanks!
Sent from my iPhone using Tapatalk
2016 Ram 2500/ /G56/ /Valair ceramic DD/ /WC fab 2nd gen swap/ /Stainless diesel 5 blade S468/83/1.0/ /Banks monster ram/ /Isspro gauges/ /MM3 tuned by DRD/
Bookmarks