68RFE Relearn - 2015 RAM 2500 Tradesman

[Truckertrash13]

I have a 2015 RAM 2500 Tradesman.

I purchased a Revmax valve body and will more than likely install it this weekend.

I was thinking of driving it to the dealership ship after installation to use the scan tool for quick learning.

Is it OK to do this?

Does the quick learn need to be performed before the truck is driven, or does it matter if it is driven to the dealership before the quick learn is performed?

It is approximately 3-5 miles from the dealership.

 0 Comment(s)

[Truckertrash13]

Just an update.

I got the valve body installed over the weekend and drove it for close to 200 miles to relearn.

The only thing I notice with the new Revmax valve body is the transmission shifts a lot smoother.

Not sure if I wasted time and money by installing one on a truck w over 400,000 miles.

If anything, it will be one part less to change if I end up w a rebuild.

 0 Comment(s)

[AK Bob]

Just an update.

I got the valve body installed over the weekend and drove it for close to 200 miles to relearn.

The only thing I notice with the new Revmax valve body is the transmission shifts a lot smoother.

Not sure if I wasted time and money by installing one on a truck w over 400,000 miles.

If anything, it will be one part less to change if I end up w a rebuild.

Just curious what was the verdict on the Quick Learn?

Did you drive to the dealership or make other arrangements?


2014 RAM 3500 (Aisin) 3.73 4X4 Limited Crew Cab Long Bed DRW. Oil Bypass Filter, Fuel Filtration Kit and 50 Gallon auxiliary fuel tank.

Sent from my iPad using Tapatalk

 0 Comment(s)