I just did a 2nd Gen swap.
What is this sensor, and what do I need to do to make it right?
Initially had a line running from hole to factory manifold its 2011 2500.
20210921_163458.jpg
I just did a 2nd Gen swap.
What is this sensor, and what do I need to do to make it right?
Initially had a line running from hole to factory manifold its 2011 2500.
20210921_163458.jpg
Sensor exhaust pressure, I believe.
If I see the picture correctly, that is located engine front on the passenger side by the lift point.
2017 WON TON CC LB 68AUTO
Secret stuff that make it vroom and whistle better Thuren 2.25 w/2.0 Fox Resi
Justin
Southern Oregon ( the Republican part)
UNITEDSTATES MARINE CORPS 1993-2007
No better friend, No better enemy.
2017 WON TON CC LB 68AUTO
Secret stuff that make it vroom and whistle better Thuren 2.25 w/2.0 Fox Resi
Justin
Southern Oregon ( the Republican part)
UNITEDSTATES MARINE CORPS 1993-2007
No better friend, No better enemy.
Yes, that's where it's located.
Do I plug it or leave it alone, or make a new line to run from 2nd Gen swap manifold to that hole?
The sensor is used for the VGT. Once the VGT is removed its not needed. I dont know about your 2nd gen set up but most turbos that are used are a 1:1 ratio so back pressure monitoring isn't that big of a issue compared to a stock VGT turbo. So clean the plug and wrap it to protect it. If you want to use it , look online
2nd gen swap and exhaust pressure sensor, you can
See what is needed.
2017 WON TON CC LB 68AUTO
Secret stuff that make it vroom and whistle better Thuren 2.25 w/2.0 Fox Resi
Justin
Southern Oregon ( the Republican part)
UNITEDSTATES MARINE CORPS 1993-2007
No better friend, No better enemy.
Bookmarks