16 RAM 2500, I installed 4.30 gears in my truck a couple of weeks ago.
While installing, I noticed an outer axle seal was leaking, so I decided to replace them while the truck was apart.
Got new seals installed, cleaned everything back up.
I never touched the rear wheel speed sensors while doing the seal swap.
After all, back together have abs, brake light, traction control lights on the dash, and service brake system message in the display.
The truck is already tuned for a new gear ratio.
I've reset abs, cleared all codes, disconnected batteries, and drove to reset.
Nothing seems to work.
Does anyone have any suggestions besides just replacing rear-wheel speed sensors?
They were in great shape and had zero issues before changing axle seals.
Bookmarks