Thanks Thanks:  2
Likes Likes:  3
Results 1 to 2 of 2

Thread: 6.7L ECU C1 Connector Pin Removal

  1. Top Of Page | #1
    Basic Member DieselDemon's Avatar

    User Info Menu

    6.7L ECU C1 Connector Pin Removal

    I need some advice on removing pins on the c1 connector for a CM2150 ECRU.

    I’m making a stand-alone harness and accidentally clipped one of the wires for the CP3, and it’s too close to the connector to solder back together.

    How do you take to remove the pins from that harness?


  2. Likes AK Bob liked this post
  3. Top Of Page | #2
    toyota_mdt_tech's Avatar

    User Info Menu

    Re: 6.7L ECU C1 Connector Pin Removal

    Quote Originally Posted by DieselDemon View Post
    I need some advice on removing pins on the c1 connector for a CM2150 ECRU.

    I’m making a stand-alone harness and accidentally clipped one of the wires for the CP3, and it’s too close to the connector to solder back together.

    How do you take to remove the pins from that harness?
    Loosen or remove the retainer, then a small pick, lift the release and slide it out.

    Wire too shot to pull, so you will have to push at the same time.

    Easier to do this if you have three hands.

    2010 Dodge 2500 SLT CCLB 4WD G56 Cummins 6.7 turbo diesel, 3.42 LSD. Add ons: Banks Monster Ram, Grid heater delete, Spyntec Free Spin Kit with Warn hubs (62672) Laramie Alloys (includes spare), "Powerwagon" Flares, Powerwagon bed decal (4X4 off road) OE Ram mudflaps, OE Slush Mats, OE Clearance Lamps, Geno's shift knob in black, 5" DPF back with muffler delete, spray in bedliner, OE brake controller, Durafit Seat Covers, Pro Tech Toolbox, Speed Turtle, Upfitter switches, Ham Radios, 8 Antennas, headache rack, emergency light bar,....

  4. Thanks AK Bob, Corkey thanked for this post
    Likes AK Bob, Corkey liked this post

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •