EGT Probe Bolt

[FireDiesel]

Gent,

Have a quick question for you.

Went to install my EGT probe however it is missing the ring inside the bolt to hold the probe in place.

Can someone enlighten me to the name of the bolt that is used to secure the probe?

EGT.PNG

 0 Comment(s)

[cumminsdieselfreak]

Gent,

Have a quick question for you.

Went to install my EGT probe however it is missing the ring inside the bolt to hold the probe in place.

Can someone enlighten me to the name of the bolt that is used to secure the probe?

EGT.PNG

Compression fitting.


Sent from my iPhone using Tapatalk

 0 Comment(s)

[FireDiesel]

Thanks, I found one on Amazon and ordered it.

By chance, would you have an idea of how much of the probe should be inserted into the #6 cylinder locating?

Using the tapped hole on the block off plate.

 0 Comment(s)

[MillsRam]

I had a question about installing a CTS3 probe myself.

The far back block off plate I have has a threaded fitting on is this the area ok to install the EGT probes?




Sent from my iPhone using Tapatalk

 0 Comment(s)

[cumminsdieselfreak]

I had a question about installing a CTS3 probe myself.

The far back block off plate I have has a threaded fitting on is this the area ok to install the egt probes?
https://uploads.tapatalk-cdn.com/202...1bbb45fed4.jpg


Sent from my iPhone using Tapatalk

Yes, that's what it's meant for.

 0 Comment(s)

[MillsRam]

So I’m about to install my Edge CTS3 probe in the pre-drilled hole on my block off plates.

The question is do I need to install a type of sealant on the threads locktite, Antiseize, Rocket?

I know I should not put it in dry what are you guys doing?


Sent from my iPhone using Tapatalk

 0 Comment(s)

[MillsRam]

ROCKSET I meant.


Sent from my iPhone using Tapatalk

 0 Comment(s)

[cumminsdieselfreak]

ROCKSET I meant.


Sent from my iPhone using Tapatalk

I'd put a touch of anti-seize on it if it were mine.

 0 Comment(s)

[Power247]

Thanks, I found one on Amazon and ordered it.

By chance, would you have an idea of how much of the probe should be inserted into the #6 cylinder locating?

Using the tapped hole on the block off plate.

It's been a long time since I installed mine but I believe the instructions were to go in till you hit the other side and then back it up a 1/4 inch.

If it doesn't reach the other side then stop before the compression nut hits the bend and lock it down there.

Greg
2019 | RAM 2500 | CCSB | 6.4 HEMI
2016 | Heartland Pioneer | DS310

 0 Comment(s)