Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: RaceME Tuner Help Needed

  1. Top Of Page | #1
    Smerseal's Avatar

    User Info Menu

    RaceME Tuner Help Needed

    So I installed a RaceME tuner today and everything went well.

    It’s tuned, but now when I drive some of the PID’s start flashing “no”, then after a few minutes the gauges start stuttering and freeze.

    A few minutes later I get a communication error.

    I reset the PID’s, unseated all connectors, and reconnected. Still getting the same result.

    Does anyone have a clue?

    Could the USB bed bad?

    Attached Images Attached Images

  2. Top Of Page | #2
    Smerseal's Avatar

    User Info Menu

    Re: RaceME Tuner Help Needed

    I figured it out!

    My truck, which I bought used had a fleet tracker shoved up under the dash, which used the original OBD port, then had a pigtail one that went into the original location.

    Took that out and everything seems great now.

    Last edited by Smerseal; 11-22-2020 at 11:05 PM. Reason: Misspelling

  3. Top Of Page | #3
    Teflon's Avatar

    User Info Menu

    Re: RaceME Tuner Help Needed

    Ok good deal.

    Sometimes splitters cause problems.

    Glad you got it fixed.

    2016. Laramie 2500, 68RFE, CC 4x4. DRD Medical plan. factory rear air. 2” lift/level. 35x12.5, Revmax vb with deep pan. ARP 425 head studs.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •