Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: RaceME Tuner Help Needed

  1. Top Of Page | #1
    Smerseal's Avatar

    User Info Menu

    RaceME Tuner Help Needed

    So I installed a RaceME tuner today and everything went well.

    It’s tuned, but now when I drive some of the PID’s start flashing “no”, then after a few minutes the gauges start stuttering and freeze.

    A few minutes later I get a communication error.

    I reset the PID’s, unseated all connectors, and reconnected. Still getting the same result.

    Does anyone have a clue?

    Could the USB bed bad?

    Attached Thumbnails Attached Thumbnails 97426D20-338A-4AC5-A199-CFCB191E6898.jpg  

  2. Top Of Page | #2
    Smerseal's Avatar

    User Info Menu

    Re: RaceME Tuner Help Needed

    I figured it out!

    My truck, which I bought used had a fleet tracker shoved up under the dash, which used the original OBD port, then had a pigtail one that went into the original location.

    Took that out and everything seems great now.

    Last edited by Smerseal; 2 Days Ago at 11:05 PM. Reason: Misspelling

  3. Top Of Page | #3
    Teflon's Avatar

    User Info Menu

    Re: RaceME Tuner Help Needed

    Ok good deal.

    Sometimes splitters cause problems.

    Glad you got it fixed.

    2016. Laramie 2500, 68RFE, CC 4x4. DRD. factory rear air. 2” level. 35x12.5, Revmax vb with deep pan. ARP 425 head studs.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •