DID my CCV Delete today nice n clean.
DID my CCV Delete today nice n clean.
diggerdave's rig...name bluedemon 2 2008 6.7 cummins
-bilstein 5100's all 5 shocks-fully deleted-greg weld ballistic rims w/35" nitto trail grappler shoes-7" canon stacks miters-H&S tuned -afe cai-iron cross front and rear bumper-buncha bd diesel parts
tonkatoy liked mine so much he just ordered one LOL
i think im gonna buy some manifold paint and rattle can
I like it. Is that a kit or a DiggerDave fabrication?
Sent from my SM-G950U using Tapatalk
2012 CCSB Saddle Brown Pearl... DRD tuned
Yea I would like to know where you got that? That looks great!
Sent from my iPhone using Tapatalk
2013 Ram 2500, 4 door, short bed, MM3 by DRD, S&B Cold Air Intake, Jamo 4inch Exhaust with muffler and tip, Shibby Plugs, Supernova V4 LED headlight bulbs
Dave: is that rascal going to omit a some what oily fume all over the engine bay?
Or is the right side (Smaller Hose) connected down below & there is a slight vacuum - pulling the oily vapor away if any?
That for sure is a nice looking clean set up!
2017 Bighorn (Delmonico Red & Chrome) CC-HD2500-4WD-6.7L-3:42w/Anti-Spin
Oil: -SHELL- Rotella T6 5W-40 & T5 15W-40 combo w/LF16035
68RFE/BW44-46/Power Steering: -Red Line- C+ ATF
Frontend & Rearend: -Red Line- SAE GL-5 75W-90NS
Many Small Mods: Interior & Exterior
Mileage: 28,541
yes basically made my own kit LOL ,,,got the catch can on amazon,,,,,shes a baffled catch can so done right with a dipstick so ya can keep an eye on it ..the oil goes in 1 way and the fumes go either out the filter or out port on the second hose all oil stays in the can ,,,same idea as all the other cars that use them ... the catchcan cost me 46 bucks canadian shipped the plug for the cai oiltube 3 bucks 2' hose 4 bucks ...notta bad kit i can make a killin LOL
Did that cause any codes to be thrown?
I’m thinking about doing the same.
My truck is DRD tuned, wasn’t sure if I can get rid of any check engine lights with the tuner for that.
2013 Ram 2500, 4 door, short bed, MM3 by DRD, S&B Cold Air Intake, Jamo 4inch Exhaust with muffler and tip, Shibby Plugs, Supernova V4 LED headlight bulbs
as soon as u take the filter out yur gonna get a code for crankcase filter restriction,,,but ,,after the instal go sit in yur truck and put the key to on position,,within 10 sec press and depress yur brake pedal ,then go to yur eccel pedal and press it 2 times the same way then turn the key to off position,,,that will reset your service blah blad light ,,,then at that time clear the codes and yur good to go
I like that setup! Gotta do something similar to mine.
I'm vented down by the axle and I get oil everywhere...specially when I'm towing heavy.
Is the smaller hose vented to the atmosphere or connected to the port on the turbskie?
Do you happen to have the link to that can?
2015 Ram 3500 CCSB SRW 4x4 G56
2020 Ram 2500 CCSB 4x4 68RFE
Never ending project. Always adding something...
Bookmarks