What is the going rate for getting headstuds Installed?
Sent from my iPhone using Tapatalk
What is the going rate for getting headstuds Installed?
Sent from my iPhone using Tapatalk
Do you need to or just want to?
If you're re-building, I don't believe it's a whole lot more than head bolts.
Some, maybe, but not enough to get excited about. I could be (and probably am) wrong about that.
But I think the factory uses bolts for ease of assembly.
I've been told that. I was told about Santa Claus, too so I've lost some faith in people.
Specifically ARP 625.
Sent from my iPhone using Tapatalk
I've only put them in when doing a rebuild so I don't know.
But a safe bet would be whatever the rate for cylinder head R&R is.
I've read some people replace them one at a time, pull a head bolt, put a stud in.
Never done it myself.
Diesel Master Tech Certified - ICML Machinery Lube Certified
2002 QCLB 2500 5.9 HO NV5600 = Ranch truck with CM Flatbed, DPS Exh/Int Manifolds, Boost Elbow
2018 CCLB 2500 ST 6.7 G56 = Glacier intake manifold & horn, Flo-pro 4" SS, MM3 with DRD 30hp tune, Valair quiet dual disc clutch, Laramie 18's powder coated black and blackout badges
Bookmarks