Thanks Thanks:  0
Likes Likes:  4
Results 1 to 5 of 5

Thread: Can’t Remove #5 and #6 Injection Lines

  1. Top Of Page | #1
    Shane09's Avatar

    User Info Menu

    Can’t Remove #5 and #6 Injection Lines

    I’ve loosened everyone but #5 and #6 and all the others were unbelievably tight so I can’t figure out any way to get them loose any special tricks?


  2. Likes AK Bob liked this post
  3. Top Of Page | #2
    Basic Member swamp donkey's Avatar

    User Info Menu

    PB Blaster.


  4. Likes AK Bob liked this post
  5. Top Of Page | #3
    Shane09's Avatar

    User Info Menu

    I let it soak over night and they won’t budge.


  6. Top Of Page | #4
    Basic Member swamp donkey's Avatar

    User Info Menu

    Are you using a line wrench?

    You can try and tighten them a little and then loosen.


  7. Likes AK Bob liked this post
  8. Top Of Page | #5
    TexNeck's Avatar

    User Info Menu

    Quote Originally Posted by Shane09 View Post
    I’ve loosened everyone but #5 and #6 and all the others were unbelievably tight so I can’t figure out any way to get them loose any special tricks
    Try and impact them / quick pop with hammer.

    Make sure you have a backup wrench on the crossover tube.

    Crows foot works well with ratchet so you can get a pipe on handle for some leverage also.

    2013 Ram 2500
    John 3:16 - Philippians 4:13

    See what we are up to on:
    FACEBOOK | INSTAGRAM
    Or Email me at:
    mike@ddpmotorsports.com
    www.ddpmotorsports.com



  9. Likes AK Bob liked this post

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •