MM3 Suction Cup Mount Problem?

[BaconLover]

Hey Guys and Gals, I just got my MM3 in from DRD.

For the life of me I can not get the suction cup mount to slide into the monitor.

It looks like the slots line up fine but I can not seem to get it to slide up into them all the way.

I have put about as much muscle into it as I feel I can with out breaking something on the monitor.

I feel dumb asking the question but is there some sort of trick to it? Seems like it should just slide up and hang out.

The Name on the mount I received is Arkon.

Attached some photos as well.

Thanks!

 0 Comment(s)

[watersupply189]

Is the monitor tight as you have it on the mount now?

I don’t use this type of bracket and mount but if it’s on there tight, then I would leave it like it is.


2016 Ram Laramie 3500 (DRD), G56, 6.7, Rough Country Leveling, HID headlights, Morimoto LED fogs plus a whole lot more!

 0 Comment(s)

[BaconLover]

No its not secure at all.

It’s actually just sitting with the weight of the monitor on the mount.

If I tilt it in any direction it will fall off

Is the monitor tight as you have it on the mount now? I don’t use this type of bracket and mount but if it’s on there tight, then I would leave it like it is.


2016 Ram Laramie 3500 (DRD), G56, 6.7, Rough Country Leveling, HID headlights, Morimoto LED fogs plus a whole lot more!

 0 Comment(s)

[AK Bob]

I haven’t used this type of mount either.

Looking at the photos I would try backing off the knurled knob in the rear first.

Give that a try if that doesn’t work try spraying a little silicone lube on the brackets.


2014 RAM 3500 (Aisin) 3.73 4X4 Limited Crew Cab Long Bed DRW. Oil Bypass Filter, 50 Gallon auxiliary fuel tank.

Sent from my iPhone using Tapatalk

 0 Comment(s)

[Gatlin118391]

I have the same problem it’s like the back of the MM3 is to thick.


Sent from my iPhone using Tapatalk

 0 Comment(s)

[Outdoornut]

It will fit ,I had same problem for about 10 minutes.
I made it go! Its good and secure now!

2012 Ram 2500 Longhorn Mega Cab,MM3 programmer, AFE Blade runner intake elbow,5" SS Exhaust

 0 Comment(s)

[2013cumminslimited]

I was just installing mine tonight.

VERY tight but it did go in.

Push hard.

 0 Comment(s)