Ok I’m doing this right now I I just want to know if I have to drill and tape a hole for the EGT sensor or can I put it in the back EGR plate?
Sent from my iPhone using Tapatalk
Ok I’m doing this right now I I just want to know if I have to drill and tape a hole for the EGT sensor or can I put it in the back EGR plate?
Sent from my iPhone using Tapatalk
Putting it in the back block off plate will be fine. Make sure the tip of the probe is not contacting the bottom of the manifold when installed.
Sent from my iPhone using Tapatalk
2012 Ram 2500 Laramie 4x4 Crew Cab 6.7 Cummins. RevMax built 68RFE "550" transmission w/ billet flexplate/low stall triple disc TC/direct oiling billet input shaft. 35"x12.50" Toyo Open Country AT2 tires on OEM 20" wheels, Thuren soft ride front springs, Thuren track bar, Thuren upper and lower control arms, Hellbent steering box brace, King 2.0 steering damper, Redhead steering box, Fox 2.0 shocks, Carli ball joints, Caterpillar fuel filter/Donaldson water separator, ARP 425 head studs, Viair onboard air compressor, airlift 5k# rear airbags, V4 LED headlights, Kenwood head unit
Thanks I was waiting for an answer running outside right now to tighten everything up
Sent from my iPhone using Tapatalk
Bookmarks