What do y’all do with these head studs?
Pull a couple bolts and replace em with these?
What do y’all do with these head studs?
Pull a couple bolts and replace em with these?
I decide to order them and give them a try, when I ordered there were 7 in stock now they are out of stock, seems like there was a quick run on them.
I will inspect and report back my findings.
Should be here tomorrow based on the tracking number.
If I don’t like what I see I’ll send them back.
Any updates on the studs?
I’ve ordered a set also.
A couple good YouTube vids to check out.
Welcome friend
2016 Ram Laramie 3500 (DRD), G56, 6.7, Rough Country Leveling, HID headlights, Morimoto LED fogs plus a whole lot more!
2016 RAM 3500 4x4 Laramie Crew Cab ,G56
friend
2016 Ram 2500 CCSB 4X4 ,Cat fuel filter delete with water seperator. Thuren suspension
with Fox IFP shocks, thuren sway bar, rear track bar and front track bar, Warn 12k winch , custom winch mount, REVMAX trans pan,HD valve body and thermal bypas. Leer truck topper,Exotic head studs, Engine enhancements by the cummins whisper.
Installed a set one by one in a 2016 G56 running MM3 from DRD along with springs, pushrods, intake horn, 369/73/.9 3rd Gen manifold swap and put down 554hp/1040tq on loaded mustang dyno.
Seem to be holding up to abuse well so far.
So far so good, I did use the ARP torque lube being its proven.
Also used ARP 1 at a time head stud replacement instructions from Glacier diesel, the paperwork with the exotics are for head gasket replacement procedures.
I've been bumping the EFi up a level every few heat cycles and all is well at 800 miles.
Came across a member selling these IFG 260ksi studs a few days ago.
Sold before I jumped on them due to some skepticism never having heard of them before.
Could be a good alternative price wise if they are legit, around $900.
Anyone with any experience on these?
Link: https://www.ifgstuds.com/shopping/
Just here for the updates.
Bookmarks