Amp Research Steps & Double R Diesel Tunes

[Keron2233]

Hey guys, I just tuned my truck with a Double R Diesel Tune witch plugs into the OBD connector. However that’s where my Amp steps were plugged into.

I know Ray at Double R Diesel says not to use an OBD SPLITTER for the tuner and the steps because there would be some kind of interference.

So my question is where did you guys move your AMP steps trigger wires to.


Sent from my iPhone using Tapatalk

 0 Comment(s)

[Power247]

Hey guys, I just tuned my truck with a Double R Diesel Tune witch plugs into the OBD connector. However that’s where my Amp steps were plugged into.

I know Ray at Double R Diesel says not to use an OBD SPLITTER for the tuner and the steps because there would be some kind of interference.

So my question is where did you guys move your AMP steps trigger wires to.


Sent from my iPhone using Tapatalk

Several guys have had good luck running the OBD splitter so you might want to try it before going through the trouble. Just make sure you are directly plugged in when installing or updating tunes.

Otherwise, AMP sells a hard wire kit that comes with instructions. Exactly where you tap wires depends on the year of your truck.

Greg
2012 | RAM 2500 | CCSB | MM3 tuned by Double R Diesel
2016 | Heartland Pioneer | DS310

 0 Comment(s)

[RamIt]

DRD MM3 Tuner & Amp Research Steps

This was discussed pretty in depth on this thread.

https://r.tapatalk.com/shareLink?sha...9&share_type=t

 0 Comment(s)

[TexNeck]

Hey guys, I just tuned my truck with a Double R Diesel Tune witch plugs into the OBD connector. However that’s where my Amp steps were plugged into.

I know Ray at Double R Diesel says not to use an OBD SPLITTER for the tuner and the steps because there would be some kind of interference.

So my question is where did you guys move your AMP steps trigger wires to.


Sent from my iPhone using Tapatalk

Mine are hardwired on so no OBD needed

 0 Comment(s)

[DDP]

We preferred hard wired as well.

 0 Comment(s)