Lost power pulling up a grade, air sensors shutting down

[easymon]

Thanks for the replies. The error code was P2281. They replaced the PCM and reprogrammed. Not feeling real confident about it.
I'm looking to replace the intake tube with the Airaid tube, has anyone tried this?

Ya check the code air leak or restriction one of the procedure with a check to air box for a restriction most dealers most dealers won't even bother to check that too because it's not a common thing . Good luck

Sent from my ONEPLUS A6013 using Tapatalk

 0 Comment(s)

[RAS]

Yes my 2017 has been setting p2281 from about 95000 miles it still doing this on hills I haven’t figured it out took it to dealer first time under warranty they reset it and said it was K&N slip in filter that caused it it has been going in to limp mode ever since it has to be over 2400 rpm it has set other codes I have had to the dealer several times it seems like this started after the first egr cooler cleaning

 0 Comment(s)

[Simpleminded]

What do you do to get it out of "Limp Mode"?

 0 Comment(s)