P0652 |
LOW VOLTAGE AT THE #1 SENSOR SUPPLY CIRCUIT from Cummins manual. |
check your connection plug for the throttle valve controller, map sensor and wires, Cam shaft sensor connection and wires.
When Monitored and Set Condition: When Monitored: With the key on.
Set Condition: Voltage detected on the
sensor supply is below a calibrated value.
POSSIBLE CAUSES
- ECM
- (F855) #1 5-VOLT SUPPLY SHORTED TO GROUND
- (F855) #1 5-VOLT SUPPLY SHORTED
- FUEL RAIL PRESSURE
- A/C PRESSURE SENSOR
- MAP SENSOR
- CAMSHAFT POSITION SENSOR
- INTERMITTENT CONDITION
DIAGNOSTIC PROCEDURE
- Turn the ignition off. Disconnect the ECM 60 pin harness connector.
NOTE: Check connectors - Clean/repair as necessary.
Turn the ignition on. Measure the voltage between the Sensor (F855) #1 5-volt Supply and the Sensor (K916) #1 Return pin at the ECM. Is the voltage between 4.5 and 5.5 volts?
Yes --> Go To 2
No --> Replace and program the ECM in accordance with the Service Information. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). - Disconnect the Pressure sensors harness connectors and the engine position sensor. Measure the resistance between the (P855) #1 sensor supply circuits at the ECM harness connector and battery negative. Is the resistance greater than 100K Ohms?
Yes --> Go To 3
No --> Repair the harness. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). - Reconnect the ECM harness connector. While monitoring with the DRBIII®, disconnect the fuel rail pressure sensor. Is DTC P0652 set?
Yes --> Go To 4
No --> Replace the Fuel rail pressure sensor. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). - While monitoring with the DRBIII®, disconnect the A/C pressure sensor. Is DTC P0652 set?
Yes --> Go To 5
No --> Replace the A/C pressure sensor. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). - While monitoring with the DRBIII®, disconnect the map sensor. Is DTC P0652 set?
Yes --> Go To 6
No --> Replace the MAP sensor. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). - While monitoring with the DRBIII®, disconnect the Camshaft position sensor. Is DTC P0652 set?
Yes --> Go To 7
No --> Replace the Camshaft position sensor. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). - Measure the resistance between the (F855) #1 sensor supply circuit of the ECM harness connector and all other circuits in both ECM harness connectors. Is the resistance greater than 100K Ohms?
Yes --> Refer to the SYMPTOM: INTERMITTENT CONDITION Symptom (Diagnostic Procedure). Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL).
No --> Repair the shorted circuit. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL
okay well I hope this helps. I have been at work since 9pm last night and I still have 3 hours to go. Thank the lord for this forum to give me things to troubleshoot and take my mind off stuff here in the ER. back to work.
Bookmarks