2015 2500 limited with push button start. I pulled the 68RFE and swapped it with a G56. Got tune for manual trans. Everything installed but can’t get truck to crank over. Need help ASAP. Thanks in advance.
2015 2500 limited with push button start. I pulled the 68RFE and swapped it with a G56. Got tune for manual trans. Everything installed but can’t get truck to crank over. Need help ASAP. Thanks in advance.
Neutral safety switch working?
Sent from my iPhone using Tapatalk
Have it bypassed. But not sure if I have the pin4 on the auto trans connector correct
I’d check there, then check to see if you have power to starter and start tracing backward. You will need to look at what circuits you need to test.
Sent from my iPhone using Tapatalk
I found pin for on the auto trans connector and have it grounded but the truck doesn’t seem to sensing it.
Something is keeping it from getting power
Sent from my iPhone using Tapatalk
These trucks are real touchy, if its controlled by a module then it will be a problem I promise you that
Sent from my iPhone using Tapatalk
I have power at the starter.
Any info on the auto trans connector pin 4? Does it need to be done on the connector for the old trans or does it need to be from further up the harness?
Did you remove anything else. Not sure if there is any tuning stuff that would need to be done with these newer trucks.
Sent from my iPhone using Tapatalk
Bookmarks