Both my ABS and Brake lights are on in the dash. i've already replaced the rear speed sensor. i just recently put new pads and rotors on the front. any one had this happen?
Both my ABS and Brake lights are on in the dash. i've already replaced the rear speed sensor. i just recently put new pads and rotors on the front. any one had this happen?
Robert dell I think had the same problem. The heck was it called?? Brake switch?
Tag us @ #igotacummins_com to have your photos reposted.
My brake lights stayed on it was the brake light switch.
There ya go. Thanks!
Tag us @ #igotacummins_com to have your photos reposted.
His sounds like the ABS sensor mite check that first.
I replaced the ABS sensor on the rear end, but i only got the sensor. How should i test the harness going to it? Also what about the one on the tranny? What does it actually monitor?
I'm having kinda the same issue. My ABS light came on shop said it was the driver side rear, I replaced it and the light is still on. It's made my cruise control be temporary OOS aswell. Not sure what else to do.
Sent from my iPhone using Tapatalk
If I remember correctly it trips a code that specifically tells you which sensors. Maybe a trip to auto zone? Also some models have the magnetic pick up in the rotors or hub maybe the new rotors dont have the magnet?
NO IT'S NOT A HEMI!
My son's 01 has had the same problem, Code ABS 63, had it since last year. Happened right after I did a front brake job. Replaced the sensor and wiring harness on top of the rear diff, still no luck. I searched for my old thread, but can't seem to find it.
*Update, found my old post: https://www.igotacummins.com/threads...rake-Lights-On
Bookmarks