Removing Emblems ?

[ZeroSignal]

Goo Gone or Kerosene are my go-to solvents for cleaning adhesives or tree sap off of paint. I always wash and wax the area afterwards to clean off any residual solvent... or use McGuire's Quick Detailer spray in a pinch.

I see a lot of guys confuse Goo Gone with "Goof Off". Goo Gone is safe for paint... Goof Off is questionable at best.

 0 Comment(s)

[DDP]

I had to use fishing line and wd40 or some type of lubricant. After the emblem itself was off i had to use an eraser wheel to get the rest off. Super easy for sure!

 0 Comment(s)

[Jaxonsram]

Fishing line and 3M adhesive remover takes all the work out of it. Should be able to get it at your local parts house or a local bump shop.

Have fun friend


Sent from my iPhone using Tapatalk

 0 Comment(s)

[BrentM]

I just used fishing line to get the emblem off, grab the corner of the tape and pulled at a 45% angle that comes off easy, soap and water. Wash the area with a good soap and water ... done.

Whole truck done in less than 30 minutes and very cheap

This is the best way, leaves very little residue, 3M adhesive remover is safe for paint and works great for what little is left.

 0 Comment(s)

[BmxRyde]

I used a heat gun and then used a fishing line to remove the emblems. Then I used my fingers to peel off the glue. 15 min job no need to us a wheel good grief people that just asking for paint flaws.

 0 Comment(s)

[DDP]

I used a heat gun and then used a fishing line to remove the emblems. Then I used my fingers to peel off the glue. 15 min job no need to us a wheel good grief people that just asking for paint flaws.

I had a terrible time removing my adhesive with my fingers LOL. Took me an hour to do one side. Used the wheel and boom done in 10 mines. Kept it nice and cool and did not stay in spot too long. Worked great!

You are definitely lucky LOL

 0 Comment(s)