I’ve read several threads on here without this simple answer.
Can you just remove the power and ground wire for the grid heater without throwing a CEL/pissing off the ECM?
I am DRD tuned
I’ve read several threads on here without this simple answer.
Can you just remove the power and ground wire for the grid heater without throwing a CEL/pissing off the ECM?
I am DRD tuned
2013 Ram 2500
John 3:16 - Philippians 4:13
See what we are up to on:
FACEBOOK | INSTAGRAM
Or Email me at:
mike@ddpmotorsports.com
www.ddpmotorsports.com
I think Ray had to turn that code off for me but I’m not 100%. It’s been almost 2 years but I think he did.
2012 Ram 2500, 4x4, 3.73, 5” lift, 35" tires, Pure Performance TB, 5100s, 4" FloPro TBE, EGR valve/cooler/throttle delete, S&B CAI, GDP heater delete, GDP S2 air horn, Bestop Powerboards, RaceME Ultra Warp Tuning by DRD
That’s what I was thinking- I’ll shoot him a note
2013 Ram 2500
John 3:16 - Philippians 4:13
See what we are up to on:
FACEBOOK | INSTAGRAM
Or Email me at:
mike@ddpmotorsports.com
www.ddpmotorsports.com
Did you get an answer for this? I'm thinking about doing the grid heater delete. I'm tuned by DRD as well, but wasn't sure if I would need him to re-tune after the heater delete
I did- they need to re-write the files so there will not be a CEL. It’s about $227 for them to make any adjustments.
Ray said for just this mod to save my money- no gain to be had.
ill hold off until turbo time comes and make it worth my $
2013 Ram 2500
John 3:16 - Philippians 4:13
See what we are up to on:
FACEBOOK | INSTAGRAM
Or Email me at:
mike@ddpmotorsports.com
www.ddpmotorsports.com
Bookmarks