68RFE TRANS LEARNING PROCESS

**CARAM** · 04-15-2019

Hi Everyone,
Does anyone know where to find the trans Learning process step-by-step after I tuned my 2018 6.7 I set her at 120 HP and just drove it for a couple of days without knowing I was supposed to re learned the transmission I now have it set the switch at 30 Hp and have driving it for about two weeks. I haven’t romped on her at all only 6,000 miles on the truck. I have noticed an occasional stall in the transmission engaging from a standstill, seems to up shift very fast and down shift slow.
Thanks for sharing.
CARAM

Sent from my iPhone using Tapatalk

0 Comment(s)

**Power247** · 04-15-2019

I'm not sure I've seen an official documented process. For my truck, I just make sure to take a week or 2 of mild around town driving after a retune before I really get into it or pull the camper.

Greg
2012 | RAM 2500 | CCSB | Custom tuned by Double R Diesel
2016 | Heartland Pioneer | DS310

0 Comment(s)

**CARAM** · 04-15-2019

At this point I’m pretty sure I’m going to have to return my truck back to stock and then reinstall my tune to get my trans tune straightened out

Sent from my iPhone using Tapatalk

0 Comment(s)

**CARAM** · 04-15-2019

Going to have to do some research don’t know if it’s safe to return my truck to stock now that it’s been deleted and then reinstall tune ? not sure how that process works. Will have to send Ray an email.

Sent from my iPhone using Tapatalk

0 Comment(s)

**RamHunter18** · 04-15-2019

Screenshot_20190415-204503_Drive.jpg

0 Comment(s)

**Rapidfire_70** · 04-15-2019

Is this only for MM3 Tuner or all tuners that are out there.. the Re-Learn Process ?

0 Comment(s)

**Power247** · 04-15-2019

Originally Posted by CARAM

Going to have to do some research don’t know if it’s safe to return my truck to stock now that it’s been deleted and then reinstall tune ? not sure how that process works. Will have to send Ray an email.

Sent from my iPhone using Tapatalk

0 Comment(s)

**Oil Stain** · 04-16-2019

Originally Posted by Rapidfire_70

Is this only for MM3 Tuner or all tuners that are out there.. the Re-Learn Process ?

Anytime you reflash the PCM from any product.

1 Comment(s)

**DDP** · 04-16-2019

This was the same one i was going to repost as well. Like stated, any time you reflash a 6.7 ecm with trans tuning this process needs to be done no matter what.

0 Comment(s)