Thanks Thanks:  0
Likes Likes:  4
Results 1 to 3 of 3

Thread: Oops!

  1. Top Of Page | #1
    Bobtipton's Avatar

    User Info Menu

    Oops!

    When I updated the firmware on the RaceMe Ultra a while back, I think I may have performed the ECM write with the key in the Accessory position. The RaceMe screen went through the ECM write without any errors. Should I re-flash with the key in the Run position?

    Thanks in advance,

    Bob


    Sent from my iPad using Tapatalk


  2. Likes walla2k5 liked this post
  3. Top Of Page | #2
    Old & Grumpy! Polaraco's Avatar

    User Info Menu

    Re: Oops!

    Quote Originally Posted by Bobtipton View Post
    When I updated the firmware on the RaceMe Ultra a while back, I think I may have performed the ECM write with the key in the Accessory position. The RaceMe screen went through the ECM write without any errors. Should I re-flash with the key in the Run position?

    Thanks in advance,

    Bob

    Sent from my iPad using Tapatalk
    I don't think that can be done in Accessory mode. Typically the device needs to read an ignition signal and needs to communicate with the ECM to run the process.

    If all seems to be well otherwise, there would be no reason why you can't reflash it.


    2003- 3500 RWD Automatic.
    S & B intake, BD Intercooler, Pusher Air Horn, MM3 Double R Tuning, Turbo Timer, electric Flex-a-lite fans, FASS 95,
    50 HP tips, upgrade to 351 turbo, 3.42 gears, Twin air compressors, air bags, Remote dual oil filters, Hellwig sway bar, Front Winch. Home made Fuel Heater, BD Exhaust brake with Torque Lock. Tons of TLC

  4. Likes david3gen, walla2k5 liked this post
  5. Top Of Page | #3
    Bobtipton's Avatar

    User Info Menu

    Re: Oops!

    Quote Originally Posted by Polaraco View Post
    I don't think that can be done in Accessory mode. Typically the device needs to read an ignition signal and needs to communicate with the ECM to run the process.

    If all seems to be well otherwise, there would be no reason why you can't reflash it.
    I didn’t get any errors. It said the ECM was programmed successfully. I’ll re-flash it.

    Thanks!

    Bob


    Sent from my iPhone using Tapatalk


  6. Likes walla2k5 liked this post

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •