Estimate On What Power I’ll Make
I think I should make 750 which is my goal it’s not finished yet but I’m on the home stretch of getting it done.
I’ve got a s467.7/83/.90 from evil fab with 80% overs with a 10mm stroker from industrial injection, Fass 165 103# valve spring, Hamilton pushrods, and a brand new bottom end crate motor blueprinted and balanced from industrial injection.
So what y’all reckon?
Estimate On What Power I’ll Make
I have a similar setup.
I have more fuel and I went 1.0 on the exhaust housing of my 467.7 made 780 hp on dyno it has room for more but I’m still ruining stock rods.
Sent from my iPhone using Tapatalk
Estimate On What Power I’ll Make
I’m still running stock rods too and a stock G56 with a southbend dual disk so we will see what goes first.
Quote:
Originally Posted by
Chrisn162001
I have a similar setup. I have more fuel and I went 1.0 on the exhaust housing of my 467.7 made 780hp on dyno it has room for more but I’m still ruining stock rods.
Sent from my iPhone using Tapatalk
Estimate On What Power I’ll Make
I'd say depending on dyno -/+ 750.
How are egts with the .90 housing and what elevation are you?
Estimate On What Power I’ll Make
Well it’s not completely finished yet I’m still waiting on my CP3 and my steed speed but I’m probably about 2-3000ft.
Re: Estimate On What Power I’ll Make
I made 735 with that same charger except with a 1.10 housing and 60% overs.
I'm only 800' above sea level though.
Re: Estimate On What Power I’ll Make
Quote:
Originally Posted by
Shane09
I think I should make 750 which is my goal it’s not finished yet but I’m on the home stretch of getting it done.
I’ve got a s467.7/83/.90 from evil fab with 80% overs with a 10mm stroker from industrial injection, Fass 165 103# valve spring, Hamilton pushrods, and a brand new bottom end crate motor blueprinted and balanced from industrial injection.
So what y’all reckon?
Sounds badass.
How are your Evil Fab parts/turbo? I'm pretty dead set on them when I get my 2nd Gen swap.
They look super solid quality.
Re: Estimate On What Power I’ll Make
Quote:
Originally Posted by
6.7 Coal Train
Sounds badass.
How are your Evil Fab parts/turbo? I'm pretty dead set on them when I get my 2nd Gen swap.
They look super solid quality.
Well I haven’t ran it yet but they are really good quality.
I messed up and thought that I got all stainless, but I didn’t so if I was you probably double check and get stainless but they are nice kits.