I appreciate it. Imma post instructions on how to do it since people seem to like it.
Printable View
So since yall seam to like it here's how to do it. If you have a long bed you may need some pipe. It requires no welding or bending. Just cutting. Only tools needed is a 14 mm socket a sawsall or grinder just something to cut the pipe. And if you've got the extra band clamp and pipe extensions that came with your flo pro exhaust you've got the hardware also if you do it save your self some trouble and put some seal glide or grease on the hangers since you'll be taking the tail pipe on and off. take the tail pipe off and cut it off just before the bend that sends it out the side. You can go ahead and reinstall the tail pipe at this point. Now what I did was loosened the clamp under the fuel filter so I could adjust the pipe that runs over the axle. You'll have to adjust that pipe and the tail pipe in conjunction to get the right angle. I tried to get it so it came out center with the corner of the bumper. Then what I did was I took the extension peice of exhaust supplied in the kit for a megacab and the extra clamp. I cut about 1/2 to 1 inch off. Then installed the 8 inch tip ( its 15 inches long pretty standard for exhaust tips) onto the extension. Makes it much easier to get the tip level since it fits pretty tight around the exhaust. Then clamp the tip and extension to what was the tail pipe. And it came out perfect for me. Doesnt stick out past the bumper. My recommendation is to not cut the extension until you test fit everything since what you need to cut off may not be what I did mainly depending on where exactly you cut the tail pipe. And for you megacab guys or if you mess up and cut too short you've got the extension piece for the long beds as a backup. I would post pictures and all but I didnt think of taking any while i was doing it. But it took me maybe 45 minutes to do it. Lemme know if you've got questions.
I vote for that look as well.
Sent from my SM-G930V using Tapatalk
I agree, this last setup looks the best. All the drone in the cab gone now?
Greg
2012 | RAM 2500 | CCSB | MM3 tuned by Double R Diesel
2016 | Heartland Pioneer | DS310
Love that sound !!
Nice job [emoji106]
"Cumminsbadgirl"
2014 Cummins Mega 3500 ( Aisin ) 4X4
MM3 Tuned by Double R Diesel