Looking for any suggestions to get that @*%#! v-band clamp on.
I’m installing 5” FLO~PR exhaust by myself and having a rough time getting it on.
Any suggestions would be greatly appreciated.
Thanks in advance.
Printable View
Looking for any suggestions to get that @*%#! v-band clamp on.
I’m installing 5” FLO~PR exhaust by myself and having a rough time getting it on.
Any suggestions would be greatly appreciated.
Thanks in advance.
Yes.. try the jack stand and if you haven’t already, remove the fender liner.. it gives you much more access...
I had my girlfriend help me.. she put the clamp on while I lined it up from below.. add some grease to the seal so it will stay on... if I were you, I would go knock on my neighbors door and ask them for help.
Pay them in beer.. LOL... after the down pipe is done it’s super simple.. use jack stands to support the exhaust pieces when lining them up.
Sent from my iPhone using Tapatalk
I used a jack stand on the end of mine but it still wanted to keep rolling out of my hands, in the end I was underneath lining it up while my girl friend locked the clamp on.
Bungee cords were very helpful.
Got the exhaust finished up and drove it to town.
All I can say is wow!
Much much faster and stronger than my old 2002 Duramax.
I just used a floor jack with the pipe tied to it for the 1 person install. But alas, I can't even lay on my back anymore.
Thanks for all the advice on the installation.
I'll be doing my by myself hope it goes smoothly.